Skip to content
Weave Assist Studio

Buying guide

Wig tape: hold types, tape vs glue, and how to apply and remove it

What lace tape does, how the hold tiers and formats differ, and the steps for a clean tape install and a gentle take-down.

Published

The underside of a brown hairpiece, showing a fine mesh center and a clear base with a zigzag edge
Photo: Lordhair / Pexels

Wig tape is double-sided adhesive tape that holds the lace or base of a wig to your skin. For a lace front, it is the middle ground between a glueless band and glue: firmer than combs and elastic, quicker and cleaner than liquid adhesive, and much easier to reposition or take off. This guide covers the hold tiers, the finishes and formats you will see, how tape compares with glue, and how to apply and remove it.

What you'll need

Essentials

  • Lace wig tape

    : double-sided tape in the hold tier and format that suit your install.
  • Small scissors

    : for cutting strips from a roll and trimming pieces to fit the hairline.
  • Remover made for tape adhesive

    : loosens the bond so the lace lifts away without pulling.

Optional

  • Rubbing alcohol and cotton pads

    : cleans oil from the skin and the lace before taping.
  • Scalp protector

    : a barrier layer some tape makers recommend for oily or sensitive skin.
  • Positioning spray

    : gives you a little time to adjust the wig before the tape grabs.

What wig tape does

The tape sits between the wig and your skin, one side stuck to the lace or base, the other to your clean, dry hairline. A thin, dull tape disappears under lace; a thick or shiny one can show through or leave a visible ridge. Because it is a solid strip rather than a liquid, there is no drying time and no risk of glue soaking through the lace onto the hair.

Tape vs glue

Wig tape Wig glue
Application Cut, peel and press; no drying Thin coats, wait until clear and tacky
Adjusting Easy to lift and reposition, especially with positioning spray Hard to move once set
Look Flat if thin and dull; edges can lift Usually the flattest hairline
Hold From one day to several weeks, by tier From one day to several weeks, by formula
Removal Remover, then wash Remover, then wash; more residue in the lace
Mess Low Higher

Many people use both: tape for everyday installs or the sides, glue for a long install or the very front. Wigs.com suggests tape for loose areas around the face such as the front hairline and side tabs. For the glue side of this choice, see our wig glue guide.

Types of wig tape

By hold time

Walker Tape, a maker of hair-system tapes, sorts its adhesives into three tiers: daily wear (1 to 7 days), extended wear (1 to 2 weeks) and maximum wear (3 to 4+ weeks). Sweat, oil and heat usually shorten any of these.

  • Daily wear tapes are for wigs you take off often, from the same day to within a few days. Walker Tape describes several of its daily-wear tapes as hypoallergenic or medical-grade gentle.
  • Extended wear tapes are for an install that stays on for about a week or two.
  • Maximum wear tapes are for multi-week installs. Walker Tape's Lace Front tape is in this tier; the maker's blog gives it a two-to-three-week hold, and its product page lists maximum wear as 2 to 4+ weeks.

By finish

Tape comes shiny, semi-dull or dull. Walker Tape describes its shiny tapes as best for poly (thin polyurethane skin) bases and points to dull or semi-dull tapes, such as No-Shine, for mesh and lace, where shine would show through; its dull Lace Front tape is described as working on any base. For a lace wig, choose a tape described as dull or made for lace.

By format

The same tape is usually sold three ways:

  • Rolls, which you cut to any length. Good if you install often or need custom pieces.
  • Straight strips, pre-cut pieces for the front and sides.
  • Contours or minis, curved or small pre-cut shapes that follow the hairline and temples.

Pre-cut pieces save time; a roll lets you cut short pieces for tight curves.

What to look at when you buy

Hold and your skin

Pick the shortest tier that covers how long you will keep the wig on. Oily skin, sweat and heat shorten any hold; Walker Tape recommends a maximum-wear tape with a scalp protector for wearers with oily or sensitive skin.

Thickness

Thinner tapes are less visible under lace. Walker Tape lists its Lace Front tape at 8.5 mil thick and describes Lace Front Thin and Walker Signature as its thinner options.

Sensitive skin

Look for tapes the maker labels hypoallergenic. Walker Tape reports a repeated insult patch test on ten of its products, including Lace Front, with 67 subjects. That is the maker's own testing, so still patch test on your own skin.

Storage

Tape loses tack with heat and humidity. Walker Tape says to store its Lace Front tape at 60 to 80°F in a cool, dark, dry place with the bag sealed, for a shelf life of up to one year.

Which tape suits whom

  • Wig off every night: a daily-wear tape, or skip tape and use a glueless band.
  • Weekly install: an extended-wear tape with careful skin prep.
  • Long installs: a maximum-wear, dull lace tape, possibly with a scalp protector.
  • Sensitive skin: a hypoallergenic tape, a patch test first, and shorter wear between breaks.

How to apply wig tape

  1. Patch test. Stick a small piece on clean skin behind your ear 24 to 48 hours ahead, as Walker Tape suggests, and skip that tape if you see redness, itching or swelling.
  2. Prep the skin and the lace. Wash and dry the hairline, remove makeup and oil, and wipe with rubbing alcohol; Walker Tape uses 99% alcohol on the skin and the lace and waits for it to evaporate completely. Pin or gel back short hairs so the tape does not catch them.
  3. Cut the pieces. Cut short strips; Wigs.com uses small pieces of about 2 inches for the hairline.
  4. Stick the tape to the wig first. Peel one liner and press the tape onto the inside of the lace, close to the edge but not so close that it shows, without touching the adhesive.
  5. Peel the second liner. If you want time to adjust, mist the exposed adhesive with a positioning spray; Walker Tape notes that more spray gives you more adjustment time.
  6. Place and press. Set the wig at your hairline, check that it is straight, then press firmly without shifting it.

For the whole install, from cap to melted lace, see how to put on a lace front wig. Tape can be melted too; see lace melt spray.

A pair of small black scissors on a beige surface
Photo: Kaboompics / Pexels

How to remove wig tape

  1. Apply the remover recommended for your tape to the lace edge and the skin underneath. For its maximum-wear Ultra Hold tape, Walker Tape says to let the remover sit and soak for at least a minute.
  2. Lift the wig gently, adding more remover wherever the tape still holds. Do not pull tape off dry.
  3. Wipe off any residue. Oil-based removers leave an oily film, so shampoo or wash the skin and rinse.
  4. Peel the old tape off the wig and clean the lace before you tape it again.

Walker Tape's alcohol-based Lace Release works differently: it is applied, left for 30 seconds, applied again, and then the wig is lifted. Follow the directions for the remover you have.

Tape and your hairline

Tape is gentler to apply than glue, but it still pulls on your skin and edges if it is removed in a hurry. Never put tape over your own hair, give your hairline breaks between installs, and stop using a tape that irritates your skin. If you notice redness that does not settle or thinning along your hairline, see a board-certified dermatologist, as the American Academy of Dermatology recommends for any hair loss.

Find more installation guides in the wig care section.

Questions

Is wig tape better than glue?

Neither is better for everyone. Tape is quicker, less messy and easier to adjust and remove, while glue usually gives a flatter, longer hold along the hairline; many wearers start with tape and move to glue for longer installs.

How long does wig tape last?

It depends on the tape and your prep. Walker Tape groups its tapes into daily wear (1 to 7 days), extended wear (1 to 2 weeks) and maximum wear (3 to 4+ weeks), and sweat, oil and heat usually shorten the hold.

What is lace tape?

Lace tape is double-sided wig tape made for lace units, usually with a dull finish so it does not shine through the lace. Walker Tape's Lace Front tape, for example, is described as dull, hypoallergenic and 8.5 mil thick.

Can you sleep in a taped wig?

Yes, extended and maximum-wear tapes are made to stay on for a week or more, nights included; daily-wear tapes hold for a shorter time, so check the front each morning. A satin scarf or bonnet at night cuts down on rubbing at the hairline.

How do you remove wig tape without hurting your edges?

Apply the remover recommended for your tape along the lace, let it sit and soak in, then lift the wig slowly, adding more remover where it still holds. For its maximum-wear Ultra Hold tape, Walker Tape says to let the remover sit for at least a minute; never pull tape off dry.

Sources