Skip to content
Weave Assist Studio

Guide

How to wash a synthetic wig: cool water, the right products and no heat

Cool water, a short gentle wash, conditioner sprayed on and a night on a wig stand: the routine that keeps synthetic fiber smooth.

Published

A wavy blonde wig with a darker root on a copper-colored mannequin head, lit by window light
Photo: RDNE Stock project / Pexels

Knowing how to wash a synthetic wig is mostly knowing what not to do: no hot water, no scrubbing, no blow dryer and no brush on wet fiber. Synthetic hair usually has its style set into the fiber at the factory, so a gentle wash in cool water should leave the style in place. This guide covers a full wash at home, drying, styling heat-friendly fiber, fixing frizz and storing the wig between wears. The same steps work for synthetic hair pieces and toppers. For a human hair unit, use the human hair wig washing guide instead.

What you'll need

Essentials

  • Wide-tooth comb

    : detangles fiber before washing without stretching or fraying it.
  • Synthetic wig shampoo

    : a gentle, usually sulfate-free formula made for synthetic fiber and used in cool water.
  • Leave-in conditioning spray for synthetic hair

    : restores slip and shine after the wash and is not rinsed out.
  • Basin or clean sink

    : holds cool water for the wash if your maker's method uses a basin.
  • Folding or open wig stand

    : air-dries the wig without stretching the wet cap.
  • Clean towel

    : blots out water without wringing.

Optional

  • Detangling spray for synthetic fiber

    : helps a comb through long or curly fiber between washes.
  • Handheld garment steamer

    : some makers use one to smooth friction frizz on synthetic fiber.

Synthetic wig care in short

Step Synthetic fiber Heat-friendly synthetic
Water Cool or cold, never hot Cool or cold, never hot
Wash Synthetic wig shampoo, short and gentle Same
Condition Leave-in spray for synthetic hair Same
Dry Air-dry on a wig stand Air-dry on a wig stand
Heat styling None Only within the maker's range
How often Every 6 to 8 wears, or about monthly Same

Before you wash

Check the fiber type

Look at the tag or the listing. If it says heat-friendly, heat-resistant or names a heat-friendly fiber, you can use limited heat later. If it says nothing, assume standard synthetic and use no heat at all.

Detangle dry

Brush or comb out tangles before the wig gets wet; wet fiber should not be combed hard. Use a wide-tooth comb and work from the ends toward the base, holding the hair above the section you are combing so you do not pull on the cap. Jon Renau says to use only a wide-tooth comb on its heat-resistant fiber, because other tools cause frizz and tangling.

On curly synthetic wigs, separate curls with your fingers instead of combing them out, so the curl pattern stays defined.

How to wash a synthetic wig, step by step

Makers use one of two methods. Both use cool water and no rubbing; follow the one on your wig's care card.

Method A: running water (Jon Renau)

  1. Wet the fiber and the base completely under cool running water, hair pointing down.
  2. Lather a small amount of shampoo in your palm and smooth it onto the base and fiber, moving downward.
  3. Do not scrub and do not soak; the directions for Jon Renau's synthetic shampoo say both in capitals.
  4. Rinse thoroughly in cool running water.

Method B: a short soak in a basin

  1. Fill a basin or sink with cool water. Headcovers uses one tablespoon of wig shampoo per basin of cold water; HairUWear uses 1 tablespoon of its CLEANSE wash in a basin of cool water.
  2. Put the wig in and move it gently through the water. Headcovers agitates for about one minute; HairUWear and UniWigs soak for 3 to 5 minutes. HairUWear warns that soaking longer than 5 minutes can damage the wig.
  3. Do not rub, twist or bunch the fiber.
  4. Rinse under cool running water, top to bottom and inside the cap, until the water runs clear and no suds are left.

Whichever method you use, the water stays cool. HairUWear puts it plainly: hot water will damage synthetic fiber.

A curly pink wig on a dark mannequin head beside a white wig and makeup pots on a dressing table
Photo: cottonbro studio / Pexels

Condition and dry

Condition with a leave-in spray

The makers' care pages here use a spray-on conditioner that stays in rather than a rinse-out one. Jon Renau says not to rinse out its conditioning spray. Headcovers suggests misting lightly from 10 to 12 inches away. HairUWear says not to spray its RESTORE mist directly on hand-tied areas, as this can loosen the knots and cause shedding. Comb the conditioner through from the ends with a wide-tooth comb, or with your fingers on curls.

Blot, then air-dry on a stand

  1. Press water out with a towel. Do not twist or wring the wig.
  2. Set it on a folding or open wig stand. HairUWear says not to dry a wig on a solid form or mannequin head, so the wet cap does not overstretch.
  3. Let it dry away from direct sun and heaters. Expect it to take overnight.
  4. Do not brush, comb hard or style until it is completely dry. CancerCare suggests arranging the strands with your fingers while it dries.

No blow dryer, even on a cool setting with a standard synthetic wig: Jon Renau and Cleveland Clinic both say not to use heat to dry or style synthetic fiber.

How often to wash a synthetic wig

Headcovers and Jon Renau both recommend every 6 to 8 wears. Cleveland Clinic suggests at least once a month, more often if you wear it daily, and CancerCare says about once a month. Wash sooner if you use hairspray or styling gel on the wig, or if it smells of smoke or sweat. Every wash wears the fiber a little, so do not wash on a schedule if the wig is still clean.

HairUWear suggests its REFRESH neutralizing spray, used as needed, to extend the time between washes.

Heat and synthetic hair

Standard synthetic: no heat at all

Curling irons, flat irons, hot rollers and blow dryers will damage standard synthetic fiber. So can heat you might not think of. CancerCare warns against heat over about 160°F, such as opening an oven, standing near a grill or putting the wig under a lamp, and UniWigs also lists ovens and barbecue grills.

Heat-friendly synthetic: low and slow

Fiber sold as heat-friendly takes some heat, but much less than human hair:

  • Jon Renau says its heat-resistant fiber can withstand up to 350°F but recommends working at 270°F to 280°F.
  • HairUWear says its Tru2Life heat-friendly fiber can take a low-medium setting up to 350°F, and tells you to use a heat protectant first.
  • Headcovers recommends 270°F to 300°F and warns that going above 300°F risks singeing even heat-friendly fiber.

Start at the bottom of those ranges, use a heat protectant made for synthetic fiber and never heat-style the wig while wearing it. Even heat-friendly fiber is still washed in cool water and air-dried; Jon Renau says not to blow-dry it.

Frizz, static and tangles

Synthetic fiber frizzes mostly from friction: at the nape, where it rubs on collars and seat backs. You cannot condition frizzed fiber back to smooth the way you can with hair.

Light frizz and static

Mist with a leave-in conditioner or detangling spray made for synthetic hair and finger-comb. For static, Headcovers says a spritz of water is enough.

Friction frizz

Jon Renau says a steamer can smooth friction frizz on standard synthetic fiber. On heat-resistant fiber, it says to correct frizz early with a flat iron, within its recommended 270°F to 280°F, before it becomes permanent damage. If the ends have frizzed hard, trimming them may be the only fix.

Storing a synthetic wig

  • Keep it on a wig stand between wears so it holds its shape. Headcovers adds: cool, dry and out of direct sunlight, and not in a steamy bathroom.
  • HairUWear says not to sleep, shower or swim in a synthetic wig, and not to use hair color on synthetic fiber.

Headcovers says a synthetic wig worn every day typically lasts four to six months. Rotating two wigs spreads the wear and gives each one time to dry fully after washing.

Common mistakes

Using your own shampoo and conditioner

Products made for your own hair are designed for a scalp, not for fiber, and wig makers make separate synthetic formulas for that reason. See the wig shampoo guide for what to look for in synthetic formulas.

Washing in warm water to "get it cleaner"

Warmer water does not clean fiber better, and HairUWear warns that hot water damages synthetic fiber. Cool water and a short wash are enough.

Brushing while wet

Wet fiber stretches and frizzes under a brush. Comb only once it is dry, or use your fingers while it dries.

Washing is one part of looking after a wig; the wig care section covers the rest, and the tools section covers stands, combs and steamers.

Questions

Do you wash synthetic wigs?

Yes. Synthetic wigs collect sweat, oil and product like any hair, so they need a gentle wash in cool water with a shampoo made for synthetic fiber, about every 6 to 8 wears or roughly once a month for most people.

Can you use regular shampoo on a synthetic wig?

A mild shampoo will clean it; CancerCare allows your own shampoo or baby shampoo. Wig makers recommend a shampoo made for synthetic fiber. Follow it with a conditioner made for synthetic hair, not the one you use on your own hair.

Can you use hot water or a blow dryer on a synthetic wig?

No. Standard synthetic fiber can be damaged by hot water and by heat tools, so wash in cool water and air-dry on a stand. Only fiber labeled heat-friendly can be heat-styled, and only within the temperature its maker lists.

How long does a synthetic wig take to dry?

Usually overnight. Headcovers notes that a wig washed in the evening is ready by morning, and CancerCare suggests leaving it to dry overnight; do not brush or style it until it is completely dry.

How long does a synthetic wig last?

Headcovers says a synthetic wig worn every day typically lasts four to six months. Gentle washing, no heat and storing it on a stand all help it reach the longer end of that range.

Sources